Non-Electric Inlets
Central Vacuums > Inlets > Non-Electric Inlets
![]()
|
Showing 1 - 9
of results
|
|
View Large Image | 3-in 1 Mounting Bracket PVC The most popular bracket for all Basic Inlet Covers. For new construction nail it to a stud. For existing home installation cut the stud side off and set it in a 2x4" drywall cutout. When piping, connect ONLY a tight 90 or coupling to the flange. Finish i
|
View Large Image | Exhaust Vent Door for Central Vacuum Pipe Installed on the outside of the home to exhaust the power unit. This is not needed with M.D.'s bag type units. Fits 2" OD (Vacuum PVC Pipe). Overall size is 3-5/8"w X 4-5/8"h
|
View Large Image | Full Face Vacuum Inlet PVC Contains low voltage connections only. There are two metal contact points inside the hole of the valve. Valves with two holes on the face of the plate that are for 110 volt electricity are under "Electric Valves". Can be installed to open up or down.
|
View Large Image | Inlet Blank Cover Plate, White (3 in a pack) Three cover plates come in one package. Use the cover plate to cover up a old vacuum hole in the sheet rock or to gain access into a wall.
|
View Large Image | Inlet Valve Extension Part#614 Use as many of these as needed when the wall, for any reason, is too thick causing the mounting plate and finished plate to not meet. Longer screws will be needed as well. It adds 3/4 of an inch to the cover plate. If that is too much you can cut to size.
|
View Large Image | Oval Door, Vacuum Inlet PVC Low voltage inlet. There are two metal contact points inside the hole of the valve. Can be installed to open up or down. Outer dimensions: 3 1/8" by 4 7/8".
|
View Large Image | Oval METAL Inlet Contains low voltage connections only. There are two metal contact points inside the hole of the valve. Metal inlets are recommended for decoration, outdoors, or in the floor. Can be installed to open up or down. All rectangle valves on this page are inte
|
View Large Image | Square Door, Vacuum Inlet PVC Low voltage inlet. There are two metal contact points inside the hole of the valve. Either wire can be connected to either screw. Can be installed to open up or down. Outer dimensions: 3 1/8" by 4 7/8"
|
View Large Image | Utility Valve with Contact Points Part#613A Valve fits into PVC Vacuum Pipe Connectors such as a coupling or 90-degree elbow (1 11/16 OD, and 1 3/8" ID). The opening for the hose to go into is 1.5 inches ID, and the widest diagonal section is 2.5 inches OD. Low voltage wire is ran from the valve to
|
;){kind=link}
;){kind=link}
;){kind=link}
', 0, 0, 'integer',
'', 'no', '1', 0, '', '', '',
1, '', 'PSLR', '', 'true', 'https://media.rainpos.com/THUMB_01477201205111210204850.jpg',
'border: 1px solid #000000 ', '', null, null, null, null, [60049],
0, 'each', 1);){kind=link}
;){kind=link}
;){kind=link}
;){kind=link}
;){kind=link}
;){kind=link}
